Since we want it to trigger for a zone type we will enter 2* You will then see a summary of the programming of that function.You will then enter *80 into your keypad – This is the section of programming that will differentiate the pulses of the siren.You will enter 00* to exit program section 79.The steps that follow will set up trigger output 17 for use (Pins 1 & 3) Enter into programming by entering your installer code and 800 on your keypad.This programming will let the sirens differentiate between burglary and fire conditions because the siren pulses differently for each condition. Now, after you have hooked the siren to the trigger pins as instructed above you will have to go into programming and enter the following information. Hook the positive of the siren to pin 3 on your Vista board.Hook the negative of the siren to pin 1 on your Vista board.You will need the wiring harness used for this purpose. If you have already exhausted the power output of terminals 3 & 4 on your Vista control panel then you can use trigger output 17 on your Vista board to trigger 1 additional siren by doing the following. Total Connect 2.0 Package Monitoring Add-Ons.Central Station Alarm Monitoring Services.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |